Product
ProductCurrent position > Product detail

Wiring of split type electromagnetic flowmeter

『Wiring of split type electromagnetic flowmeter』Related information(v cone flow meter|rotary gas meter|gallon meter|gear meter|metal tube rotameter|glass tube rotameter|nutating disk meter|transit time ultrasonic flow meter|wedge flow meter|pd meters|hydraulic flow meter|ultrasonic water flow meter|water flow meter|air flow meter|magnetic water flow meter|oxygen flow meter|gas flow meter|argon flow meter|air velocity meter|gasoline flow meter|fuel flow meter|ultrasonic water meter|digital water meter|nitrogen flow meter|solid flow meter|Oxygen tank flow meter|digital water flow meter|diesel fuel flow meter|steam flow meter|02 flow meter|compressed air flow meter|oil flow meter|liquid flow meter)

1. Magnetic electric torque sensor

2. What is the wiring diagram of the flowmeter? How is the flowmeter wired? The wiring method of the flowmeter may vary depending on the type and brand. Here are two common wiring methods for flow meters for your reference.

1. Wiring method for split type flow meters: As shown in the above figure, the sensor and accumulator of the split type flow meter are installed separately and connected through signal cables. When wiring, it is necessary to connect the output signal of the sensor to the input terminal of the integrator. Generally speaking, the wiring method of a split type flowmeter is relatively simple. Simply connect the corresponding signal line to the integrator.

2. Wiring method of an integral flowmeter: As shown in the diagram, the integral flowmeter integrates the sensor and integrator together without the need for signal cables.

. When wiring, it is necessary to connect the output signal of the sensors dead end finger to the input terminal of the integrator. The wiring method of the integral flowmeter is relatively simple, just connect the corresponding signal line to the accumulator. It should be noted that different types of flow meters have different wiring methods, so it is necessary to carefully read the user manual of the flow meter before wiring to understand the correct wiring method. At the same time, safety should be taken into account during the wiring process to avoid contact with live parts or dangerous operations.

3. Wiring diagram of split type sewage electromagnetic flowmeter

The wiring of split type sewage electromagnetic flowmeter is divided into two parts: internal wiring and external wiring. The following is a det

Wiring of split type electromagnetic flowmeter
ailed explanation: the internal wiring is the connection between the sensor and the conversion amplifier, with a total of 5 wires, as follows: excitation coil wiring: 2 wires, marked as XY, used to provide current to the excitation coil and generate a stable magnetic field.

. Electrode wiring: 2 wires, labeled AB, used to collect induced electromotive force signals generated by fluid flow. Grounding wire: 1, marked as C, used to connect the sensor housing to the ground, ensuring equipment safety and reducing interference. External wiring is mainly used for power input and signal output, as follows: Power input terminal: 2 wires, used to connect external power sources (usually 24V DC) to provide working power for the flowmeter. Signal output line: 6 wires, divided into the following three categories: 4-20mA output line: 2 wires, used for transmitting differential current signals proportional to flow rate, suitable for long-distance transmission and connection with PLC, DCS and other systems. RS232 communication cable: 2 wires, used for short distance serial communication, can be connected to a computer or upper computer for data acquisition and parameter setting. RS485 communication cables: 2, used for long-distance serial communication, supporting multi-point communication, suitable for distributed control systems in industrial sites. Grounding terminal wire: located on the cylinder, used to ground the flowmeter as a whole, ensuring equipment safety and reducing electromagnetic interference. Grounding precautions for wiring: If the pipeline is made of non-conductive plastic material, it must be properly grounded, otherwise it may cause inaccurate flow measurement or signal drift. The grounding resistance should be les

『SILVER Official Website SERVICE』

Copyright2026SILVER E-Commerce
[email protected]
+86 15365082610